Description
- This is a Kit of the no-moving parts Wind Speed Meter. We have redrawn the PCB so that the 2x16 LCD fits on top of the main PCB.
- The schematics have been redrawn but we have kept the same Component Designators. An Off/on switch and input protection diode have been added.
- Ten mm nylon standoffs in each corner raise the PCB and allow the two switches S2 and S3 to come out. Also access to VR1 and VR2 is easy since both trimpots are mounted underneath the PCB.
- Access to test points with a CRO is also easy with this arrangement. We did not keep the In Circuit Programming header.
- Skill Level : Kit - Basic Soldering Required
This is a Kit of the no-moving parts Wind Speed Meter. We have redrawn the PCB so that the 2x16 LCD fits on top of the main PCB. The schematics have been redrawn but we have kept the same Component Designators. An Off/on switch and input protection diode have been added. Ten mm nylon standoffs in each corner raise the PCB and allow the two switches S2 and S3 to come out. Also access to VR1 and VR2 is easy since both trimpots are mounted underneath the PCB. Access to test points with a CRO is also easy with this arrangement. We did not keep the In Circuit Programming header.